Changes

# Using double sided tape, stick internal battery to the bottom part of the device case. Battery should be glued approximately 15 millimeters from the bottom wall of the case. ''Picture on the left''.

# Using double sided tape, stick internal battery to the bottom part of the device case. Battery should be glued approximately 15 millimeters from the bottom wall of the case. ''Picture on the left''.

# Connect battery to the PCB.

# Connect battery to the PCB.

# Place PCB into the bottom case by firstly inserting PCB part where antenna is located. Afterwards, press down PCB part where pins are located.

# Place PCB into the bottom case by firstly inserting PCB part where antenna is located.

'''Note:''' be gentle and careful not to damage or bend antenna.

'''Note:''' be gentle and careful not to damage or bend antenna.