Changes

135 bytes added ,  14:02, 22 October 2021
Line 222: Line 222:  
To configure FM with BTSMP1 EYE Sensor:
 
To configure FM with BTSMP1 EYE Sensor:
   −
# In [[FMB120 System settings|System settings]] Enable [[Codec#Codec%208%20Extended|Codec8 Extended]];  
+
'''Step 1:''' Check EYE App Settings:
 +
 
 +
# Make sure that name of the sensor is default length (10 symbols) in [[EYE SENSOR / BTSMP1#Configure%20window|EYE App Basic Configuration window]]
 +
# Note what Packet settings you have set in [[EYE SENSOR / BTSMP1#Configure%20window|EYE App Basic Configuration window]]
 +
'''Step 2:''' Configure FM device using Teltonika configurator:
 +
# In [[FMB120 System settings|System settings]] Enable [[Codec#Codec%208%20Extended|Codec8 Extended]];
 
# In [[FMB120 GPRS settings|GPRS settings]] Configure [[FMB120 GPRS settings#GPRS%20Settings%20and%20Server%20Settings|GPRS Settings and Server Settings]]
 
# In [[FMB120 GPRS settings|GPRS settings]] Configure [[FMB120 GPRS settings#GPRS%20Settings%20and%20Server%20Settings|GPRS Settings and Server Settings]]
 
# In [[FMB120 Bluetooth settings|Bluetooth]] settings Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)", otherwise Bluetooth will be disabled;
 
# In [[FMB120 Bluetooth settings|Bluetooth]] settings Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)", otherwise Bluetooth will be disabled;
 
# In [[FMB120 Bluetooth 4.0 settings|Bluetooth 4.0]] settings:
 
# In [[FMB120 Bluetooth 4.0 settings|Bluetooth 4.0]] settings:
 
## set Non Stop Scan to "Disable", configure "Update Frequency" and "Scan duration" as 30 seconds. These settings will bring the best results for BLE scanning with our device;
 
## set Non Stop Scan to "Disable", configure "Update Frequency" and "Scan duration" as 30 seconds. These settings will bring the best results for BLE scanning with our device;
## In [[FMB120 Bluetooth 4.0 settings#Advanced%20Mode|Bluetooth 4.0 settings Advanced Mode Settings]] Load EYE Sensor preset according to the set Eye Sensor protocol set in [[EYE SENSOR / BTSMP1#Configure%20window|EYE App Basic Configuration window]]
+
## In [[FMB120 Bluetooth 4.0 settings#Advanced%20Mode|Bluetooth 4.0 settings Advanced Mode Settings]] Load EYE Sensor preset according to packet settings in EYE app(if you do not have preset you can download them from below table)
## Configure MAC address of the sensor 
+
## Configure MAC address of the sensor
# Make sure that name of the sensor is default length (10 symbols) in [[EYE SENSOR / BTSMP1#Configure%20window|EYE App Basic Configuration window]]
  −
 
  −
If you do not have preset you can download them from below table:
      
<br>'''Advanced mode configuration:'''
 
<br>'''Advanced mode configuration:'''

Navigation menu