1,645
edits
Changes
→DualCam update procedure
* After the update, it would be advisable to format SD cards again.
* After the update, it would be advisable to format SD cards again.
=== '''Potential issues and solutions''' ===
Update is pretty straightforward most of the time. However, sometimes the update does not trigger. In case it doesn’t and the camera does not update, check whether it is really disconnected from FMx125 device. If it is, do not power off the camera at first. Keep it powered on and take out and put back in both SD cards. After this, wait 60-90s again and check the firmware version using “camgetver”.
If it still is not updated, disconnect from FMx125, power the camera off for at least 20 seconds and power it back on. Wait for a few minutes and then re-insert the cards again. Reconnect and check the firmware version using “camgetver”.
Can also note that if just one camera updates, only front or only rear, all mentioned solutions and steps could be done to only camera.
Reminder, that the rear camera is with IR LEDs and light sensor and the front one is without them.
==Troubleshoot==
==Troubleshoot==
