Changes

[[Image:Fmb120_autogeofence.png|300px|right]]

[[Image:Fmb120_autogeofence.png|300px|right]]

AutoGeofence is based on the last known position after the movement has stopped. If your car is being taken away – you can be notified using this function. The shape and size of the geofence zones are set by parameters. It is possible to state whether entering in or out of the geofence triggers an asynchronous message.

AutoGeofence is based on the last known position after the movement has stopped. You can be notified using this function if your car is taken away. The shape and size of the geofence zones are set by parameters. It is possible to state whether entering in or out of the geofence triggers an asynchronous message.

AutoGeofencing options can be configured by following parameters as depicted in the right hand side figure.<br/>Activation timeout defines the delay between when the ignition is turned off and the creation of AutoGeofence within set Radius value around vehicle's last position. Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility.<br/>AutoGeofence can be deactivated by:

AutoGeofencing options can be configured by following parameters as depicted in the right hand side figure.<br/>Activation timeout defines the delay between when the ignition is turned off and the creation of AutoGeofence within set Radius value around vehicle's last position. Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility.<br/>AutoGeofence can be deactivated by:

* Digital Input 1 – If DIN1 voltage becomes equal or higher than 6.9 V.

* Digital Input 1 – If DIN1 voltage becomes equal or higher than 6.9 V.