46
edits
Changes
Teltonika FMx 640 With TCP Link Mode (view source)
Revision as of 15:31, 12 December 2022
, 15:31, 12 December 2022no edit summary
'''2.''' Second step after the connections, you must configure the FMx640:
'''2.''' Second step after the connections, you must configure the FMx640:
The FMx configurator you have to set parameters for COM1 or COM2 (depends on which COM port you are using) in global parameters window. You have to modify the server sittings to you PC IP and your TCP port.
The FMx configurator you have to set parameters for COM1 or COM2 (depends on which COM port you are using) in global parameters window. You have to modify the server sittings to you PC IP and your TCP port.
[[File:1 server Fuad.jpg|center|thumb|1007x1007px|Configuring server sitting]]
[[File:1 server Fuad.jpg|center|thumb|1020x1020px|Configuring server sitting]]
[[File:Configure RS232 Sittings FMC640.jpg|center|thumb|1010x1010px|Configure RS232 Sittings]]
[[File:Configure RS232 Sittings FMC640.jpg|center|thumb|1012x1012px|Configure RS232 Sittings]]
· Modify the Mode from silent to TCP/UDP Ascii mode.
· Make sure that the Baud rate is matching with the baud rate in the terminal, in our example it is the sensor
· Make sure that the Baud rate is matching with the baud rate in the terminal, in our example it is the sensor
In this step we need to use the terminal log. When you want to send a message from FMx 640 to the server, write it in Terminal but change your com port and select port which is assigned for COM1/COM2.
In this step we need to use the terminal log. When you want to send a message from FMx 640 to the server, write it in Terminal but change your com port and select port which is assigned for COM1/COM2.
[[File:Terminal Log Sending Text.png|center|thumb|1112x1112px|Terminal Log Sending Text]]
[[File:Terminal Log Sending Text.png|center|thumb|1062x1062px|Terminal Log Sending Text]]
After doing the mentioned configuration you can type your message in the marked field, check +CR and press Send button. If sent successfully, you will see it in Hercules Received data field.
After doing the mentioned configuration you can type your message in the marked field, check +CR and press Send button. If sent successfully, you will see it in Hercules Received data field.
[[File:Receiving Text From The Terminal to Server Hercules.png|center|thumb|800x800px|Receiving Text from The Terminal to Server Hercules]]
[[File:Receiving Text From The Terminal to Server Hercules.png|center|thumb|727x727px|Receiving Text from The Terminal to Server Hercules]]