1,650
edits
Changes
no edit summary
==DualCam Checks==
==DualCam Checks==
*Check RS232 configuration, baud rate, etc. Default values should be set for the DualCam.
*Check RS232 configuration, baud rate, etc. Default values should be set for the DualCam.
*See if both cameras are working. Try sending separate picture requests and check the result. “camreq:1:1” for the front camera and “camreq:1;2” for the rear camera. Possible responses to "camreq" command - [[https://wiki.teltonika-gps.com/view/DualCam_SMS_commands#Camera_request_command|Camera request command]]
*See if both cameras are working. Try sending separate picture requests and check the result. “camreq:1:1” for the front camera and “camreq:1;2” for the rear camera. Possible responses to "camreq" command - [[DualCam SMS commands#Camera request command|Camera request command]]
Check camera IO values in the configurator.
Check camera IO values in the configurator.
*See if the camera is physically enabled, gets power, and re-check the RS232 connections. You can also test if the camera is physically enabled by covering the light sensor on the rear camera '''(marked green in the picture below)'''. The rear camera’s IR LEDs should turn on by doing so in a dark environment.
*See if the camera is physically enabled, gets power, and re-check the RS232 connections. You can also test if the camera is physically enabled by covering the light sensor on the rear camera '''(marked green in the picture below)'''. The rear camera’s IR LEDs should turn on by doing so in a dark environment.
