Changes

'''Please note that camera must be connected to an ignition source, in other way the camera will drain battery'''

'''Please note that camera must be connected to an ignition source, in other way the camera will drain battery'''

'''Also, some RJ45 cables have two modifications, some have RS232 output on 3/4 pins some on 5/6 pins'''

'''Also, some RJ45 cables have two modifications, some have RS232 output on 3/4 pins some on 5/6 pins'''

For FMX640 devices, RJ45 cable is required with one end cut and loose. Connect the RJ45 cable to the FMX640 device's port 1 or port 2, both slots have RS232 support. Once connected, the other end of the cable should have pin 5-Rx, and 6-Tx shaved and connected to ADAS camera Rx and Tx cable. For the rest of the connection please refer to the picture below.  

For FMX640 devices, RJ45 cable is required with one end cut and loose. Connect the RJ45 cable to the FMX640 device's port 1 or port 2, both slots have RS232 support. Once connected, the other end of the cable should have pin 5-Rx, and 6-Tx shaved and connected to ADAS camera Rx and Tx cable. For the rest of the connection please refer to the picture below.[[File:Adas112233.jpeg]]  

 

 

[[File:Adas112233.jpeg]]

'''ADAS connection with relay'''

'''ADAS connection with relay'''