Changes

Line 25: Line 25:  
[[Image:Data_protocol.gif|300px]]
 
[[Image:Data_protocol.gif|300px]]
   −
*In ''RS232 \ RS485 settings tab'', make sure to choose '''DualCam''' to '''COM1/COM2 settings''', and set the required '''baudrate'''.
+
*In ''RS232 \ RS485 settings tab'', make sure to enable '''Camera interface''' by "Enable", and select '''DualCam''' in the Mode drop-down menu, afterwards '''DualCam COM1''' and '''Camera I/O''' should appear in the tab list.
As soon as '''DualCam''' is selected, ''COM1 Camera'' and ''Camera I/O settings'' tabs will appear in the configurator menu.
     −
[[Image:DualCam config.gif|600px]]
+
[[Image:Dualcam enable.gif|600px]]
    
*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''
 
*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''
 
'''
 
'''
[[File:Dualcam IO.gif|500px]]
+
[[File:Dualcam Camera IO.gif|500px]]
 
'''
 
'''
   −
*In appeared ''COM1 Camera tab'', make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DualCam" Scenario Settings''
+
*In appeared ''DualCam COM1'' tab, make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DualCam" Scenario Settings''
 +
 
 +
[[File:Dualcam COM 1.gif|500px]]
     

Navigation menu