322
edits
Changes
no edit summary
[[File:DSM server.jpg|300px]]
[[File:DSM server.jpg|300px]]
==FMC650 DashCam Configuration==
[[Firmware_versions#PROFESSIONAL_trackers|'''(!) Required firmware version''']]. [[FMC650_firmware_errata|Firmware errata.]]
*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]
[[Image:Data_protocol.gif|300px]]
*In ''RS232 \ RS485 settings tab'', make sure to enable '''Camera interface''' by "Enable", and select '''DashCam''' in the Mode drop-down menu, afterwards '''DashCam COM1''' and '''Camera I/O''' should appear in the tab list.
[[Image:Dashcam config.gif|600px]]
*Make sure to change '''Camera I/O''' camera state '''Priorities''' to ''Low''
'''
[[File:DashCam priority.gif|500px]]
'''
*In appeared ''DashCam COM1'' tab, make sure to '''configure everything by your needs''', and do not forget to complete the '''"Domain"''' and '''"Port"''' settings in ''"DashCam" Scenario Settings''
[[File:DashCam COM1.png|500px]]
*'''''NOTE:''''' ''This is a base setup for the device to work properly. Other device configuration is made according to your needs.
''
*'''''NOTE:''''' ''There are different settings for picture quality and compression, these settings will affect picture/video sizes and upload speeds. For more information about transfer sizes and timings, please visit our [[DashCam_Camera_Manual#DashCam_data_transfer_timing | DashCam Data Transfer Timing]] section
''
==General settings==
==General settings==
