2,538
edits
Changes
→System Settings
|===Speed source===
|===Speed source===
If TFT100 is used with CAN modification extra settings option will we available for choosing Speed source.
If TFT100 is used with CAN modification extra settings option will we available for choosing Speed source.
Available speed source: GNSS or CAN.
If CAN Speed source enabled, it will retrieve speed from CAN data, but if the speed value from CAN data is 0, speed will be retrieved from GNSS data if Position Fix acquired, even though it is not configured.
[[Image:Screenshot 2024-03-01 at 14-09-53 5.2. System - Mobility documentation.png]]
[[Image:speed_source.PNG]]
[[Image:speed_source.PNG]]
}}
}}
Here user can change battery charger settings, where charging is allowed.
Here user can change battery charger settings, where charging is allowed.
Battery will be charged: '''''On Need''''' (battery will be charged anytime when it needs to be charged) and '''''After Ignition ON''''' (battery will be charged only when ignition is on).
Battery will be charged: '''''On Need''''' (battery will be charged anytime when it needs to be charged) and '''''After Ignition ON''''' (battery will be charged only when ignition is on).
Three charging modes is available:
* On neeed: charger enabled if external voltage is higher than 5.05 voltage and Battery Voltage is below 3.90V. Charging is disabled if device enters any sleep mode.
* After Ignition On: charger enabled after ignition is turned on, except if the battery is fully charged or 10-minute timeout has not passed since the device was turned on for faster FIX receiving.
* Always: charger is always enabled, except if the battery is fully charged or 10-minute timeout has not passed since the device was turned on for faster FIX receiving.
[[Image:Screenshot 2024-03-01 at 14-11-41 5.2. System - Mobility documentation.png]]
}}
}}
|}
|}
|===Analog Input Value Range===
|===Analog Input Value Range===
User can choose analog input range of 15 V or 150 V.
User can choose analog input range of 15 V or 150 V.
Input range used to determine lowest voltage for DIN1 and DIN2 activation.
[[Image:Screenshot 2024-03-01 at 14-13-04 5.2. System - Mobility documentation.png]]
Lowest voltage to enabled DIN for 15V range - 2.5V
Lowest voltage to enabled DIN for 150V range - 9V
}}
}}
|}
|}
