FTC961 First Start: Difference between revisions

FTC961 First Start (view source)

Revision as of 14:56, 18 April 2024

571 bytes added , 18 April

no edit summary

VisualWikitext

Airidas.S

Administrators

2,459

edits

@@ Line 46: / Line 46: @@
 =='''MOUNTING RECOMMENDATIONS'''==
-'''DEVICE FASTENING'''
+'''CONNECTING WIRES'''
-• Locate the battery in your vehicle. If present remove the battery cover to access the battery.
+* Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or moving objects should be kept away from the wires.<br />
+* There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied.<br />
-• There is a double sided tape on the back of the device, use it to attach the device on the battery, so that the GNSS antenna
+* If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be <br />applied and the wires should not be loose.<br />
-and LEDs indicators are facing up.
+* Wires cannot be connected to the board computers or control units.<br />
 '''CONNECTING POWER SOURCE'''
-• Device power wire is designed to be directly connected to the positive terminal fastener of the vehicle battery.
+* Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.<br />
+* When module is connected, measure voltage again to make sure it did not decrease.<br />
+* It is recommended to connect to the main power cable in the fuse box.<br />
+* 3 A, 125 V external fuse shall be used.<br />
 '''CONNECTING GROUND WIRE'''
-• Connect ground wire to the vehicle frame or metal parts that are fixed to the frame.
+* Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.<br />
+* If the wire is fixed with the bolt, the loop must be connected to the end of the wire.<br />
-• If the wire is fixed with the bolt, the loop must be connected to the end of the wire.
+* For better contact scrub paint from the spot where loop is going to be connected.<br />
-• Device ground wire is designed to be directly connected to the negative terminal fastener of the vehicle battery.
 [[Category:FTC961]]