Changes

* Locate the battery in your vehicle. If present remove the battery cover to access the battery.

* Locate the battery in your vehicle. If present remove the battery cover to access the battery.

* There is a double sided tape on the back of the device, use it to attach the device on the battery, so that the GNSS antenna and LEDs indicators are facing up.

* There is a double sided tape on the back of the device, use it to attach the device on the battery, so that the GNSS antenna

 

and LEDs indicators are facing up.

 

'''CONNECTING POWER SOURCE'''

'''CONNECTING POWER SOURCE'''

* Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.<br />

* Device power wire is designed to be directly connected to the positive terminal fastener of the vehicle battery.

* When module is connected, measure voltage again to make sure it did not decrease.<br />

* It is recommended to connect to the main power cable in the fuse box.<br />

* 3 A, 125 V external fuse shall be used.<br />

'''CONNECTING GROUND WIRE'''

'''CONNECTING GROUND WIRE'''

* Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.<br />

* Device ground wire is designed to be directly connected to the negative terminal fastener of the vehicle battery.

* If the wire is fixed with the bolt, the loop must be connected to the end of the wire.<br />

* For better contact scrub paint from the spot where loop is going to be connected.<br />

[[Category:FTC881]]

[[Category:FTC881]]