Changes

{{{image1|[[Image:FMB630_autoCAN1.png|center|200px]]}}}

{{{image1|[[Image:FMB630_autoCAN1.png|center|200px]]}}}

* SCAN scans once for available messages on CAN bus;

* SCAN - scans once for available messages on CAN bus;

* Monitoring – toggles scanning of messages on CAN bus every 3 seconds;

* Monitoring – toggles scanning of messages on CAN bus every 3 seconds;

* Offline Configuration – enables CAN configuration when {{{model|FMB630}}} is not connected to CAN bus;

* Offline Configuration – enables CAN configuration when {{{model|FMB630}}} is not connected to CAN bus;

* Value – shows scanned value of parameter;

* Value – shows scanned value of parameter;

* Send data to server – allows to choose the type of data when it‘s generated:

* Send data to server – allows to choose the type of data when it‘s generated:

o Disabled – Data will not be collected

* Disabled – Data will not be collected

o On low priority – records will be generated as low priority events;  

* On low priority – records will be generated as low priority events;  

o On high priority – records will be generated as high priority events and immediately sent to server via GPRS (if GPRS is available);

* On high priority – records will be generated as high priority events and immediately sent to server via GPRS (if GPRS is available);

o On panic - records will be generated as panic priority events and immediately sent to server via GPRS, if GPRS is not available records will be sent via SMS messages;

* On panic - records will be generated as panic priority events and immediately sent to server via GPRS, if GPRS is not available records will be sent via SMS messages;

* Data acquisition type – allows to choose when records are generated:

* Data acquisition type – allows to choose when records are generated:

oMonitoring – monitors data;

*Monitoring – monitors data;

oOn change – record is generated when parameter value is changed;

*On change – record is generated when parameter value is changed;

oHysteresis – record is generated when increasing parameter value becomes higher than High value, and decreasing becomes less than Low value

*Hysteresis – record is generated when increasing parameter value becomes higher than High value, and decreasing becomes less than Low value

oEvent on exit – record is generated when parameter value becomes higher than High value or lower than Low value;

*Event on exit – record is generated when parameter value becomes higher than High value or lower than Low value;

oEvent on entrance – record is generated when parameter value becomes between High and Low values;

*Event on entrance – record is generated when parameter value becomes between High and Low values;

oEvent on both – record is generated when parameter value crosses High or Low values;

*Event on both – record is generated when parameter value crosses High or Low values;

* Low – allows to choose low value for Data acquisition;

* Low – allows to choose low value for Data acquisition;

* High – allows to choose High level for Data acquisition;

* High – allows to choose High level for Data acquisition;