Changes

Line 154: Line 154:       −
'''CAN \ Tachograph''' are used to configure device when connection of CAN1 and CAN2 BUS lines are performed. <br>
+
==Remote Data Download (RDD) via FMS==
   −
Teltonika recommendations: <br>
+
When RDD (Remote Data Download) signal available on '''FMS'''.
   −
* FMB640 FMM640 and FMC640 CAN1 connected to vehicle's FMS(J1939) BUS line<br>
+
Applies to:
* FMB640 FMM640 and FMC640 CAN2 connected to vehicle's Tachograph - Instructions can be found on [[FMB640_and_Tachograph_Solution|FMB640 and Tachograph Solution]] [https://wiki.teltonika-gps.com/view/FMC640_CAN_%5C_Tachograph FMC640 and Tachograph Solution] [https://wiki.teltonika-gps.com/view/FMM640_CAN_%5C_Tachograph FMM640 and Tachograph Solution] wiki page;
+
* DAF CF - LF - XF
 +
* IVECO Stralis I / II/ Hi-Way
 +
* Renault D / Magnum DXI & E-TECH / Midlum DXI / Premium DXI / Renault T-K-C
 +
* Volvo FH - FM - FL
 +
 
 +
If the '''RDD''' signal is available on the '''FMS''' interface, no additional connection is required. In this case, the '''CANx LOW and HIGH''' wires from the FMx640 are connected to '''PIN 6 and 9''' on the '''FMS''' connector.
 +
Additionally, '''PIN 10''' can be used for ignition detection using '''DIN1''' wire.
 +
 
 +
[[image:FMS_connector.png|central]]
 +
[[image:FMS_connector1.png|central]]
 +
 
 +
More information about FMS CABLE can be found on [https://teltonika-gps.com/product/fms-cable/ Teltonika Page] <br><br><br>
 +
 
 +
For the following vehicles regarding the '''RDD''', please contact the manufacturer:
 +
* MAN TGX - TGA - TGL - TGM
 +
* Mercedes Actros / Antos / Atego / Arocs / Axor II
 +
* Scania R - P - G - S
 +
 
 +
If the '''RDD''' signal is '''NOT''' available on the '''FMS''' interface, you need to retrieve the '''RDD''' data by connecting to the tachograph's C connector using provided instructions below.