Line 154: |
Line 154: |
| | | |
| | | |
− | '''CAN \ Tachograph''' are used to configure device when connection of CAN1 and CAN2 BUS lines are performed. <br>
| + | ==Remote Data Download (RDD) via FMS== |
| | | |
− | Teltonika recommendations: <br>
| + | When RDD (Remote Data Download) signal available on '''FMS'''. |
| | | |
− | * FMB640 FMM640 and FMC640 CAN1 connected to vehicle's FMS(J1939) BUS line<br> | + | Applies to: |
− | * FMB640 FMM640 and FMC640 CAN2 connected to vehicle's Tachograph - Instructions can be found on [[FMB640_and_Tachograph_Solution|FMB640 and Tachograph Solution]] [https://wiki.teltonika-gps.com/view/FMC640_CAN_%5C_Tachograph FMC640 and Tachograph Solution] [https://wiki.teltonika-gps.com/view/FMM640_CAN_%5C_Tachograph FMM640 and Tachograph Solution] wiki page;
| + | * DAF CF - LF - XF |
| + | * IVECO Stralis I / II/ Hi-Way |
| + | * Renault D / Magnum DXI & E-TECH / Midlum DXI / Premium DXI / Renault T-K-C |
| + | * Volvo FH - FM - FL |
| + | |
| + | If the '''RDD''' signal is available on the '''FMS''' interface, no additional connection is required. In this case, the '''CANx LOW and HIGH''' wires from the FMx640 are connected to '''PIN 6 and 9''' on the '''FMS''' connector. |
| + | Additionally, '''PIN 10''' can be used for ignition detection using '''DIN1''' wire. |
| + | |
| + | [[image:FMS_connector.png|central]] |
| + | [[image:FMS_connector1.png|central]] |
| + | |
| + | More information about FMS CABLE can be found on [https://teltonika-gps.com/product/fms-cable/ Teltonika Page] <br><br><br> |
| + | |
| + | For the following vehicles regarding the '''RDD''', please contact the manufacturer: |
| + | * MAN TGX - TGA - TGL - TGM |
| + | * Mercedes Actros / Antos / Atego / Arocs / Axor II |
| + | * Scania R - P - G - S |
| + | |
| + | If the '''RDD''' signal is '''NOT''' available on the '''FMS''' interface, you need to retrieve the '''RDD''' data by connecting to the tachograph's C connector using provided instructions below. |