Changes

no edit summary
Line 1: Line 1:  +
[[File:1 FMB + DAF.png|800px|center]]
    +
==Installation proccess==
 +
 +
* Below is shown main installation location:
 +
 +
[[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]]]
 +
 +
* Carefully unscrew the fuse panel screws and fold the panel down.
 +
 +
[[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]]]
 +
 +
* Where to find main connector?
 +
 +
[[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]]]
 +
 +
* Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
 +
 +
[[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]]]
 +
 +
* After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
 +
 +
[[Category:FMB640 Manual]]