How to Install FMB640 on DAF XF: Difference between revisions
no edit summary
(Blanked the page) |
No edit summary |
||
| Line 1: | Line 1: | ||
[[File:1 FMB + DAF.png|800px|center]] | |||
==Installation proccess== | |||
* Below is shown main installation location: | |||
[[File:2 Fuse panel cover.png|800px|center|Fuse panel cover]]] | |||
* Carefully unscrew the fuse panel screws and fold the panel down. | |||
[[File:3 Fuse panel and screws location.png|800px|center|Fuse panel and screws location]]] | |||
* Where to find main connector? | |||
[[File:4 Main FMS connector location.png|800px|center|Main FMS connector location]]] | |||
* Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection. | |||
[[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]]] | |||
* After installation and device configuration of FMB6 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also. | |||
[[Category:FMB640 Manual]] | |||