TAT1XY Battery Replacement Instructions: Difference between revisions
(Created page with "{{ Template:TATXYZ_TATXYZ_Battery_Replacement_Instructions |model=TAT141 }} Category:TAT141 Manual") |
No edit summary |
||
| Line 1: | Line 1: | ||
{{ | {{ | ||
Template: | Template:TATXYZ Battery Replacement Instructions | ||
|model=TAT141 | |model=TAT141 | ||
}} | }} | ||
[[Category:TAT141 Manual]] | [[Category:TAT141 Manual]] | ||
Latest revision as of 13:22, 25 April 2024
Main Page > Autonomous Trackers > TAT141 > TAT141 Manual > TAT1XY Battery Replacement InstructionsPDF version of the instructions - HERE.
Hardware version B2 (without the hole in the PCB) - HERE.
TATxyz Battery Replacement Instructions
1. Remove the cap (use something thin enough to fit the groove)
2. Using the hole in the PCB pull the board out
3. Unplug the battery
4. Take the battery out leaving the battery holder on the PCB
5. Place the new battery with cables facing the same way and connect it
6. Place the PCB back into the housing with GNSS antenna facing the same side as the engraving on the case. Then close the cap.
