Difference between revisions of "LV-CAN200"
From Wiki Knowledge Base | Teltonika GPS
| Line 1: | Line 1: | ||
| − | [[File:LV- | + | [[File:LV-CAN200_08.png|right|250px]] |
[https://teltonika.lt/product/lv-can200/ LV-CAN200] is designed to acquire [https://en.wikipedia.org/wiki/CAN_bus CAN Bus] data from: | [https://teltonika.lt/product/lv-can200/ LV-CAN200] is designed to acquire [https://en.wikipedia.org/wiki/CAN_bus CAN Bus] data from: | ||
* Light vehicles (including electric cars) | * Light vehicles (including electric cars) | ||
Revision as of 16:24, 13 November 2019
Main Page > CAN Trackers & Adapters > LV-CAN200
LV-CAN200 is designed to acquire CAN Bus data from:
- Light vehicles (including electric cars)
- Trucks
- Buses and coaches
Access to CAN Bus data enables fleet operators to report on a wide range of information. You can effectively identify areas of improvement within their vehicle operation to drive down overheads and minimize environmental impact.
Supported vehicles features*
- Total fuel consumption
- Fuel level (Dashboard)
- Vehicle mileage — Vehicle mileage from dashboard or Vehicle mileage counted (from adapter installation)
- Door status — Front left door, Front right door, Rear right door, Rear left door, Trunk cover, Engine cover (hood)
- Engine speed (RPM)
- Oil pressure/level status
- Engine temperature
- Vehicle speed
- Accelerator pedal position
- CNG level
- Total CNG consumption
- Engine is working on CNG
* Number of parameters depends on vehicle model, year and equipment.
Technical features
| PARAMETER | VALUE | ||||
|---|---|---|---|---|---|
| Minimum | Typical | Typical | Maximum | Unit | |
| Supply Voltage | |||||
| Supply Voltage (Recommended Operating Conditions) | +9 | +12 | +24 | +63 | V |
| Current Consumption | |||||
| Working Mode | 10,6 | 5,3 | mA | ||
| Sleep Mode | 0,4 | 0,2 | mA | ||
| Operating Temperature | |||||
| Operating Temperature | -40 | +85 | °C | ||
Adapter changes
| Manufacture date | Software date | Program No. digits | Program No. in connection scheme | Changes |
|---|---|---|---|---|
| >= 2018-01-01 | >= 2018-01-01 | 5 | XXXX → XXXXX |
|
| <2018-01-01 | >= 2017-09-01 | 4 | XXX → XXXX |
|
| < 2017-09-01 | 3 | XXX |
FAQ
- How to connect LV-CAN200 to:
- Troubleshooting LV-CAN200, ALL-CAN300, CAN-CONTROL
- Connection scheme shows the use of a resistor. What power resistor should I choose?
- Connection scheme shows two CAN wires of the same color connected to one connector
- How to capture CAN adapter log from FMX1YX?
- How to capture CAN adapter log from FM device?
- How to update CAN adapter Over The Air
- Immobilizing and locking issues using CAN-Control with Immobilizer
- CAN adapter supported vehicles
- What to do if the FM device shows old program number instead of new configured one?
YouTube
Teltonika CAN adapters Part 1: Introduction
Teltonika CAN adapters Part 2: Installation
Product Change Notifications
Promotional Material
LV-CAN200 Promotional Material
