Template:FMB6 debug
Document is dedicated for debugging FMB6XY devices.
For successful device debug, make sure that your device firmware version is the latest:
FMS
Usually FMS DEBUG is needed, when certain FMS parameters are not being received on the server. Steps to resolve FMS parameter issue:
1. Required parameters are configured in FMS I/O section
2. Vehicle is moving or has Ignition ON
FMS | Description |
---|---|
1 | Brake switch |
1 | Wheel based speed |
1 | Cruise control active |
1 | Clutch switch |
1 | PTO state |
1 | Accelerator pedal position |
1 | Engine percent load at current speed |
1 | Engine total fuel used |
1 | Fuel level |
1 | Engine speed |
1 | Axle position |
1 | Tire location |
1 | Axle weight |
1 | Engine total hours of operation |
1 | Vehicle identification number |
1 | SW-version supported |
1 | Diagnostics supported |
1 | Requests supported |
1 | High resolution total vehicle distance |
1 | Service distance |
1 | Vehicle motion |
1 | Driver 2 working state |
1 | Driver 1 working state |
1 | Vehicle overspeed |
1 | Driver 1 time rel. state |
1 | Driver 2 time rel. state |
1 | Driver 1 card |
1 | Driver 2 card |
1 | Direction indicator |
1 | Tachograph performace |
1 | Handling operation |
1 | System event |
1 | Tachograph vehicle speed |
1 | Engine coolant temperature |
1 | Ambient air temperature |
1 | Driver 1 / 2 identification numbers |
1 | Fuel rate |
1 | Instantaneous fuel economy |
1 | At least one PTO engaged |
1 | High resolution engine total fuel used |
1 | Combined Vehicle Weight |
1 | Brake Pedal Position |
1 | AdBlue |