Template:FMB6 debug

From Wiki Knowledge Base | Teltonika GPS

Document is dedicated for debugging FMB6XY devices.
For successful device debug, make sure that your device firmware version is the latest:

FMS[edit source]


Usually FMS DEBUG is needed, when certain FMS parameters are not being received on the server. Steps to resolve FMS parameter issue:
1. Required parameters are configured in FMS I/O section
2. Vehicle is moving or has Ignition ON

FMS Description
1 Brake switch
1 Wheel based speed
1 Cruise control active
1 Clutch switch
1 PTO state
1 Accelerator pedal position
1 Engine percent load at current speed
1 Engine total fuel used
1 Fuel level
1 Engine speed
1 Axle position
1 Tire location
1 Axle weight
1 Engine total hours of operation
1 Vehicle identification number
1 SW-version supported
1 Diagnostics supported
1 Requests supported
1 High resolution total vehicle distance
1 Service distance
1 Vehicle motion
1 Driver 2 working state
1 Driver 1 working state
1 Vehicle overspeed
1 Driver 1 time rel. state
1 Driver 2 time rel. state
1 Driver 1 card
1 Driver 2 card
1 Direction indicator
1 Tachograph performace
1 Handling operation
1 System event
1 Tachograph vehicle speed
1 Engine coolant temperature
1 Ambient air temperature
1 Driver 1 / 2 identification numbers
1 Fuel rate
1 Instantaneous fuel economy
1 At least one PTO engaged
1 High resolution engine total fuel used
1 Combined Vehicle Weight
1 Brake Pedal Position
1 AdBlue

Tachograph[edit source]