Changes

Speed Limiting Solution (view source)

Revision as of 09:15, 26 October 2021

513 bytes removed , 09:15, 26 October 2021

no edit summary

Line 26: Line 26: −

To have a working solution it’s important to properly wire the devices. In the picture below it's shown how to correctly wire the device.

+

To have a working solution it’s important to properly wire the devices. In the picture below it's shown how to correctly wire the device using the electronic throttle controller

[[File:MSP500 schema 1.7.png|783x783px]]

There are 2 other ways of connecting the MSP500 device which are displayed below:

+

[[File:Fuel Pump Installation.png|none|thumb|875x875px]]

+

[[File:Solenoid Installation.png|none|thumb|960x960px]]

During installation please follow recommendations in order to '''avoid damaging''' device and vehicle:

Line 318: Line 321:

|}

−

~~Speed limiting is activated when max speed is exceeded.~~

−

~~Security State Flag Examples:~~

−

*1) Locked doors 00 80 00 00 30 00 00 05

−

*2) Unlocked doors 00 80 00 00 00 00 00 05

−

~~Convert HEX value to BIN value:~~

−

~~Then count 28'th BIT from the back (28'th bit value shows locked/unlocked states)~~

−

*1) 10000000000000000000000000110000000000000000000000000101

−

*2) 10000000000000000000000000000000000000000000000000000101

−

~~If car is locked value is 1 and if car is unlocked value is 0~~

−

~~To test~~ the ~~car unlocking and locking use these GPRS commands~~

+

Speed limiting is activated when max speed is exceeded. Relay is activated on DOUT1 which can either disable the acceleration pedal, turn off the fuel pump or close the solenoid valve. Only one scenario can be used per MSP500 device.

−

* 1) To unlock all doors use this command: "lvcanopenalldoors"

−

*2) To lock all doors use this command: "lvcanclosealldoors"

−

//

[[Category: Usage scenarios]]

Anonymous user

212.59.13.227