Difference between revisions of "How to Install FMC650 on DAF XF"
From Wiki Knowledge Base | Teltonika GPS
(Created page with "800px|center ==Installation proccess== * Below is shown main installation location: 800px|center|Fuse panel cover...") |
|||
| Line 19: | Line 19: | ||
[[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]] | [[File:5 FMB640 and DAF XF connection wires.png|800px|center|FMB640 and DAF XF connection]] | ||
| − | * After installation and device configuration of | + | * After installation and device configuration of FMC650 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also. |
[[Category:FMC650 Manual| 9]] | [[Category:FMC650 Manual| 9]] | ||
Latest revision as of 17:27, 2 February 2022
Main Page > Professional Trackers > FMC650 > FMC650 Manual > How to Install FMC650 on DAF XF
Installation proccess
- Below is shown main installation location:
- Carefully unscrew the fuse panel screws and fold the panel down.
- Where to find main connector?
- Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
- After installation and device configuration of FMC650 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
