Difference between revisions of "Why does TAT100 not send data?"
From Wiki Knowledge Base | Teltonika GPS
m (Protected "Why does TAT100 not send data?" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
|||
| Line 36: | Line 36: | ||
[[Category: TAT100 FAQ]] | [[Category: TAT100 FAQ]] | ||
| − | |||
Latest revision as of 13:45, 14 April 2023
Main Page > Autonomous Trackers > TAT100 > TAT100 FAQ > Why does TAT100 not send data?1. Make sure Tracking settings are configured correctly, according to these instructions
2. Check if your APN , Domain and Port entered correctly and GPRS data is Enabled. |
3. In some rare cases it helps to clear the device's memory:
It could be done remotely using SMS/GPRS command sdformat.
More info about the commands here.
|
NOTE! Please do not change Open Link Timeout in TAT100 configuration
GPRS -> Record Settings -> Open Link Timeout -> Should be set to [30] / Response Timeout -> Should be set to [30] / Network Ping Timout -> Should be set to [0] |
|
|
NOTE! Scheduler days has to be selected to enable data sending. More info here. |
