1,247
edits
Changes
Template:FMT1 Mounting recommendations (view source)
Revision as of 07:52, 12 June 2018
, 07:52, 12 June 2018no edit summary
<font size="+1"><span style=color:#F49E21> 1. </span> Connecting wires </font>
<font size="+1"><span style=color:#F49E21> 1. </span> Connecting wires </font>
<font size="+0">
<font size="+1">
* Wires should be fastened to the other wires or non-moving parts. Try to avoid heat emitting and moving objects near the wires.
* Wires should be fastened to the other wires or non-moving parts. Try to avoid heat emitting and moving objects near the wires.
* The connections should not be seen very clearly. If factory isolation was removed while connecting wires, it should be applied again.
* The connections should not be seen very clearly. If factory isolation was removed while connecting wires, it should be applied again.
<font size="+1"><span style=color:#F49E21> 2. </span> Connecting power source. </font>
<font size="+1"><span style=color:#F49E21> 2. </span> Connecting power source. </font>
<font size="+0">
<font size="+1">
* Be sure that after the car computer falls asleep, power is still available on chosen wire. Depending on car, this may happen in 5 to 30 minutes period.
* Be sure that after the car computer falls asleep, power is still available on chosen wire. Depending on car, this may happen in 5 to 30 minutes period.
* When module is connected, measure voltage again to make sure it did not decrease.
* When module is connected, measure voltage again to make sure it did not decrease.
