Changes

Created page with "To check or OBD data is available from OBD device, please do the following: 1.Send to device the command obdinfo. Response details: Returns OBD info. Protocol, VIN, Adaptive..."
To check or OBD data is available from OBD device, please do the following:
1.Send to device the command obdinfo.
Response details:
Returns OBD info. Protocol, VIN, AdaptiveTiming value, requested PID counter, OBD application state, available vehicle PIDs, mil status, number of DTCs
For example: Protocol:6,VIN:WVWZZZAUZFW125650,TM:0,CNT:11,ST:PROTOCOL DETECTION,P1:0x98180001,P2:0x1,P3:0xE0800020,P4:0x0,Fuel:OFF,MIL:0,DTC:0,ID0
According to obdinfo response you can check available OBD parameters via OBD Pid Reader. OBD reader can be found here: https://www.glmsoftware.com/Downloads1.aspx


Protocol:6 – specifies car supported protocol
VIN:WVWZZZAUZFW125650 -specifies car vin number
ST:PROTOCOLDETECTION- specifies OBD application state
P1:0x98180001,P2:0x1,P3:0xE0800020,P4:0x0 - specifies available vehicle PIDs. These values specifies available parameters in car. If all pids values 0 (P1:0x0,P2:0x0,P3:0x0,P4:0x0), it means that OBD parameters is not readable.
MIL:0 - mil status, indicates state of the led(0- OFF, 1-ON)
DTC:0 - number of errors
Please find additional information here:
https://wiki.teltonika-gps.com/view/FMB001_Supported_OBD_protocols
https://wiki.teltonika-gps.com/view/Template:FMB_Device_Family_Parameter_list#OBD_II_.28Blue-tooth.29

Navigation menu