333
edits
Changes
Immobilizing and locking issues using CAN-Control + Immobilizer (view source)
Revision as of 10:52, 22 January 2021
, 10:52, 22 January 2021Created page with "== Struggle after upgrading CAN-CONTROL to CAN-CONTROL+Immobilizer? == Possible encounters after upgrading CAN bus adapter: * Vehicle doors Lock/Unlock is not working; * Vehi..."
== Struggle after upgrading CAN-CONTROL to CAN-CONTROL+Immobilizer? ==
Possible encounters after upgrading CAN bus adapter:
* Vehicle doors Lock/Unlock is not working;
* Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''".
If You encounter with any of these issues - follow solution steps below.
== Solution ==
After installation is completed and CAN bus adapter program is set, please, follow these steps:
# Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times''';
# Send GPRS command - " lvcansetprog 11120" (or any other). Program number must contain 5 digits.
# Send GPRS command - " lvcansetprog ''the one that is for Your vehicle model''". Program number can be seen in at the top of the CAN adapter connection scheme.
# After receiving a response to a command, repeat the learning procedure (first step).
{|
|-
| [[File:Alert.png|left|link=]] || <b>'''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]].
After completed these steps, commands to open/close and to block/unblock engine can be performed.
All SMS/GPRS responses should inform You that particular command has been completed successfully.</b>
|}
<bR>
{|
|-
| [[File:Alert.png|left|link=]] || <b>'''Note''': if installing CAN-CONTROL adapter into different vehicle - program should be changed according to the vehicle model and learning must be initiated ("first solution step").
If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated.
</b>
|}
Possible encounters after upgrading CAN bus adapter:
* Vehicle doors Lock/Unlock is not working;
* Vehicle doors Lock/Unlock is working but engine Blocking/Unblocking does not and after sending commands, the response is: "''CAN-CONTROL cmd not supported''".
If You encounter with any of these issues - follow solution steps below.
== Solution ==
After installation is completed and CAN bus adapter program is set, please, follow these steps:
# Do a learning procedure - using the vehicle key, unlock and lock vehicle '''three''' '''times''';
# Send GPRS command - " lvcansetprog 11120" (or any other). Program number must contain 5 digits.
# Send GPRS command - " lvcansetprog ''the one that is for Your vehicle model''". Program number can be seen in at the top of the CAN adapter connection scheme.
# After receiving a response to a command, repeat the learning procedure (first step).
{|
|-
| [[File:Alert.png|left|link=]] || <b>'''Note''': Before SMS text, two space symbols should be inserted if no SMS username or password was set in [[FMB001 SMS/Call settings|SMS / Call settings]].
After completed these steps, commands to open/close and to block/unblock engine can be performed.
All SMS/GPRS responses should inform You that particular command has been completed successfully.</b>
|}
<bR>
{|
|-
| [[File:Alert.png|left|link=]] || <b>'''Note''': if installing CAN-CONTROL adapter into different vehicle - program should be changed according to the vehicle model and learning must be initiated ("first solution step").
If adapter will be installed again on the previous vehicle - program number needs to be restored and learning step must be repeated.
</b>
|}