0
edits
Changes
→Vehicle installation
== Vehicle installation ==
== Vehicle installation ==
1. Clean the spots on the windshield with the ''alcohol wipe'' where you plan to mount the hardware. Remove the red 3M tape and mount the main unit underneath the rear-view mirror as centered (left/right) and straight as possible (if it ''must be off center'' by a few inches, that’s okay – measurements will be taken later). Be certain not to obstruct the drivers view.[[File:Vehinst1.jpg|center|frameless|191x191px|d<br />]]
1. Clean the spots on the windshield with the ''alcohol wipe'' where you plan to mount the hardware. Remove the red 3M tape and mount the main unit underneath the rear-view mirror as centered (left/right) and straight as possible (if it ''must be off center'' by a few inches, that’s okay – measurements will be taken later). Be certain not to obstruct the drivers view.
[[File:Vehinst1.jpg|frameless|191x191px|d<br />]]
2. Run the main-unit cable across the headliner and down to the driver side under-dash. This may require removing the A-pillar temporarily. Follow factory harnesses, always run behind any airbags.
2. Run the main-unit cable across the headliner and down to the driver side under-dash. This may require removing the A-pillar temporarily. Follow factory harnesses, always run behind any airbags.
3. Attach the mount (from the plastic bag) and stick the LCD indicator on the windshield in the driver’s line-of-sight, usually close to the A-pillar so it can be easily seen and controlled if required. Run this cable down to the driver’s under-dash as well.[[File:Vehinst2.jpg|center|frameless]]
3. Attach the mount (from the plastic bag) and stick the LCD indicator on the windshield in the driver’s line-of-sight, usually close to the A-pillar so it can be easily seen and controlled if required. Run this cable down to the driver’s under-dash as well.
[[File:Vehinst2.jpg|frameless]]
4. Once both cables are run to the under-dash, connect them to the provided PCI unit at the proper ports.
4. Once both cables are run to the under-dash, connect them to the provided PCI unit at the proper ports.
5. Connect the Teltonika FMx125,FMX225 tracker to the main unit using RS232 cable. Please refer connection scheme below.
5. Connect the Teltonika FMx125,FMX225 tracker to the main unit using RS232 cable. Please refer connection scheme below.
[[File:ADAS wiring scheme 2.png|center|frameless|1160x1160px]]
[[File:ADAS wiring scheme 2.png|center|frameless|1160x1160px]]
6. Connect the provided Power/Ground harness connection to a chassis ground (black wire) and Ignition source (red wire). The circuit must provide ~3 Amp @12v. Connect the plug to the PCI unit at the ‘Power’ port.
6. Connect the provided Power/Ground harness connection to a chassis ground (black wire) and Ignition source (red wire). The circuit must provide ~3 Amp @12v. Connect the plug to the PCI unit at the ‘Power’ port.
[[File:Vehinst8.png|center|frameless|357x357px]]
[[File:Vehinst8.png|frameless|357x357px]]
== Installation: for CAN-equipped vehicles ==
== Installation: for CAN-equipped vehicles ==
