Changes

7.      Correct firmware update will be signaled by device start-up led message.

7.      Correct firmware update will be signaled by device start-up led message.

==Device configuration==

==Device configuration==

Setting up NBL-2 device to connect with FMB device. Go to Teltonika configurator -> Bluetooth 4.0 and set it up like it shown in this screenshot (MAC adress will depend on your particular NBL sensor):[[File:NBL conf10.jpg.png|frameless|1128x1128px]]

Setting up NBL-2 device to connect with FMB device. Go to Teltonika configurator -> Bluetooth 4.0 and set it up like it shown in this screenshot (MAC adress will depend on your particular NBL sensor):

 

[[File:Nbl2 1.png|frameless|660x660px]]

 

 

[[File:Nbl2 2.png|frameless|350x350px]]

Then go to I/O settings:  

Then go to I/O settings:  

Make sure to enable BLE Custom 1 parameter (ID: 51190) and set operand to „On Change“.

Make sure to enable BLE RFID #1 parameter (ID: 51740) and set operand to „On Change“.

[[File:NBL conf11.jpg.png|frameless|1127x1127px]]

[[File:Nbl2 3.png|frameless|999x999px]]

==Setting up Private/Business mode==

==Setting up Private/Business mode==

Make sure to enable Private/Business mode in Trip/Odometer settings. It can be done using SMS commands or configurator. Not every device has these parameters visible in the configurator, therefore they should be configured via SMS commands. It can be done by sending  ''setparam'' SMS (how to send SMS commands: [[FMB120 SMS/GPRS Commands|https://wiki.teltonika-gps.com/view/FMB120_SMS/GPRS_Commands]]). Set it to High or Low priority (parameter ID: 11850). Enable triggers as NBL-1 Button1 or NBL-1 Button2 (parameter ID: 11811).

Make sure to enable Private/Business mode in Trip/Odometer settings. It can be done using SMS commands or configurator. Not every device has these parameters visible in the configurator, therefore they should be configured via SMS commands. It can be done by sending  ''setparam'' SMS (how to send SMS commands: [[FMB120 SMS/GPRS Commands|https://wiki.teltonika-gps.com/view/FMB120_SMS/GPRS_Commands]]). Set it to High or Low priority (parameter ID: 11850). Enable triggers as NBL-1 Button1 or NBL-1 Button2 (parameter ID: 11811).

[[File:NBL conf12.jpg.png|none|thumb|500x500px]]

[[File:NBL conf12.jpg.png|none|thumb|500x500px]]

Don‘t forget to save all these changes to device and you are ready to test NBL-2 sensor.

Don‘t forget to save all these changes to device and you are ready to test NBL-2 sensor.