TFT100 First Start: Difference between revisions
m
no edit summary
(Created page with "<b>{{{description|Small, professional and waterproof tracker for forklifts, E-mopeds and E-scooters with internal high gain GNSS/GSM antennas, Bluetooth, high capacity interna...") |
mNo edit summary |
||
| Line 151: | Line 151: | ||
|Status window image=[[Image:TFT100-Status-Screen.png|1000px|]] | |Status window image=[[Image:TFT100-Status-Screen.png|1000px|]] | ||
|SMS/GPRS Commands= [[TFT100 SMS/GPRS Commands|SMS parameters]] | |SMS/GPRS Commands= [[TFT100 SMS/GPRS Commands|SMS parameters]] | ||
}} | |||
=='''Mounting recommendations'''== | |||
{{{connecting_wires|* <big>Connecting wires</big> | |||
{{{plugged_in|** Wires should be connected while the module is not plugged in.}}} | |||
:* Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or moving objects should be kept away from the wires. | |||
:* There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied. | |||
:* If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be applied and the wires should not be loose. | |||
:* Wires cannot be connected to the board computers or control units. | |||
}}} | |||
{{{connecting_power_source|* <big>Connecting power source</big> | |||
** Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period. | |||
** When module is connected, measure voltage again to make sure it did not decrease. | |||
** It is recommended to connect to the main power cable in the fuse box. | |||
** 3 A, 125 V external fuse shall be used. | |||
}}} | |||
{{{connecting_ignition|* <big>Connecting ignition wire</big> | |||
**Be sure to check if it is a real ignition wire i. e. power does not disappear after starting the engine. | |||
**Check if this is not an ACC wire (when key is in the first position, most of the vehicle electronics are available). | |||
**Check if power is still available when you turn off any of vehicles devices. | |||
**Ignition is connected to the ignition relay output. As alternative, any other relay, which has power output when ignition is on, may be chosen. | |||
}}} | |||
{{{connecting_ground_wire|* <big>Connecting ground wire</big> | |||
**Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame. | |||
**If the wire is fixed with the bolt, the loop must be connected to the end of the wire. | |||
**For better contact scrub paint from the spot where loop is going to be connected. | |||
}}} | |||
{{{pay_attention|{{Template:Pay_attention|model={{{model|FMB2YX}}}}}}}} | |||
[[Category:TFT100]] | [[Category:TFT100]] | ||