TFT100 First Start: Difference between revisions

TFT100 First Start (view source)

511 bytes removed , 27 March 2023

m

6,023

edits

@@ Line 159: / Line 159: @@
 :* There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied.
 :* If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be applied and the wires should not be loose.
-:* Wires cannot be connected to the board computers or control units.
-}}}
-{{{connecting_power_source|* <big>Connecting power source</big>
-** Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.
-** When module is connected, measure voltage again to make sure it did not decrease.
-** It is recommended to connect to the main power cable in the fuse box.
-** 3 A, 125 V external fuse shall be used.
 }}}