420
edits
Changes
Template:TATXYZ Battery Replacement Instructions (view source)
Revision as of 14:19, 25 April 2024
, 25 AprilCreated page with "PDF version of the instructions - DOWNLOAD.<br> Hardware version B2 (without the hole in the PCB) - Media:TAT battery replacement - no..."
PDF version of the instructions - [[Media:TAT battery replacement.pdf|DOWNLOAD]].<br>
Hardware version B2 (without the hole in the PCB) - [[Media:TAT battery replacement - no hole on PCB v1.1.pdf|DOWNLOAD]].<br>
<br>
<b>TATxyz Battery Replacement Instructions</b> <br>
1. Remove the cap (use something thin enough to fit the groove)<br>
[[File:Cap.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br><br>
2. Using the hole in the PCB pull the board out<br>
[[File:PCB pull.jpg|alt=|left]]<br><br><br><br><br><br><br><br><br><br><br>
3. Unplug the battery<br>
[[File:Unplug bat.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br>
4. Take the battery out leaving the battery holder on the PCB<br>
[[File:Take out.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br>
5. Place the new battery with cables facing the same way and connect it<br>
[[File:Connect.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br>
6. Place the PCB back into the housing with GNSS antenna facing the same side as the engraving on the case. Then close the cap.<br>
[[File:Housing.jpg|alt=|left|400x400px]]<br>
Hardware version B2 (without the hole in the PCB) - [[Media:TAT battery replacement - no hole on PCB v1.1.pdf|DOWNLOAD]].<br>
<br>
<b>TATxyz Battery Replacement Instructions</b> <br>
1. Remove the cap (use something thin enough to fit the groove)<br>
[[File:Cap.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br><br>
2. Using the hole in the PCB pull the board out<br>
[[File:PCB pull.jpg|alt=|left]]<br><br><br><br><br><br><br><br><br><br><br>
3. Unplug the battery<br>
[[File:Unplug bat.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br>
4. Take the battery out leaving the battery holder on the PCB<br>
[[File:Take out.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br>
5. Place the new battery with cables facing the same way and connect it<br>
[[File:Connect.jpg|alt=|left|400x400px]]<br><br><br><br><br><br><br><br><br><br><br><br><br><br>
6. Place the PCB back into the housing with GNSS antenna facing the same side as the engraving on the case. Then close the cap.<br>
[[File:Housing.jpg|alt=|left|400x400px]]<br>
