Changes

m
Text replacement - "Bluetooth" to "Bluetooth®"
Line 53: Line 53:  
|Panel  display is turned on or off
 
|Panel  display is turned on or off
 
|-
 
|-
|Bluetooth broadcast or not
+
|Bluetooth® broadcast or not
 
|0x0400
 
|0x0400
 
|When  on, BT icon cannot control.
 
|When  on, BT icon cannot control.
Line 59: Line 59:  
When  off, BT icon can define status: flash or always
 
When  off, BT icon can define status: flash or always
 
|-
 
|-
|Bluetooth icon always on or off
+
|Bluetooth® icon always on or off
 
|0x0800
 
|0x0800
 
|BT  icon is shown or not
 
|BT  icon is shown or not
 
|-
 
|-
|Bluetooth icon flash or off
+
|Bluetooth® icon flash or off
 
|0x1000
 
|0x1000
 
|BT  icon is flashing or not
 
|BT  icon is flashing or not
Line 112: Line 112:  
**1 - ON <br />
 
**1 - ON <br />
 
**0 - OFF <br />
 
**0 - OFF <br />
*In the example above, parameters from 1<sup>st</sup> ''instruction table'' are chosen. Those parameters are: ''Display battery level is ON; Error icon is ON; Bluetooth Broadcast is ON; Panel display is ON; Display speed is ON; Display unit is ON; Use mph units is ON.'' <br />
+
*In the example above, parameters from 1<sup>st</sup> ''instruction table'' are chosen. Those parameters are: ''Display battery level is ON; Error icon is ON; Bluetooth® Broadcast is ON; Panel display is ON; Display speed is ON; Display unit is ON; Use mph units is ON.'' <br />
 
*When the parameters which you would like to enable are chosen, open ''Calculator'' software in ''Programmer'' mode, ''BIN'' (Binary) field again. <br />
 
*When the parameters which you would like to enable are chosen, open ''Calculator'' software in ''Programmer'' mode, ''BIN'' (Binary) field again. <br />
 
*[[Image:Alert.png|20px|left]]<u>Starting '''from the bottom''' of the instruction table and '''moving upwards'''</u>, type the values (0/1) in the ''Calculator'' depending on if the parameter should be '''enabled''' (Value 1) or '''disabled''' (Value 0). <br />
 
*[[Image:Alert.png|20px|left]]<u>Starting '''from the bottom''' of the instruction table and '''moving upwards'''</u>, type the values (0/1) in the ''Calculator'' depending on if the parameter should be '''enabled''' (Value 1) or '''disabled''' (Value 0). <br />

Navigation menu