Command:scsetconfig: Difference between revisions
m
Text replacement - "Bluetooth" to "Bluetooth®"
m (Protected "Command:scsetconfig" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
m (Text replacement - "Bluetooth" to "Bluetooth®") |
||
Line 53: | Line 53: | ||
|Panel display is turned on or off | |Panel display is turned on or off | ||
|- | |- | ||
| | |Bluetooth® broadcast or not | ||
|0x0400 | |0x0400 | ||
|When on, BT icon cannot control. | |When on, BT icon cannot control. | ||
Line 59: | Line 59: | ||
When off, BT icon can define status: flash or always | When off, BT icon can define status: flash or always | ||
|- | |- | ||
| | |Bluetooth® icon always on or off | ||
|0x0800 | |0x0800 | ||
|BT icon is shown or not | |BT icon is shown or not | ||
|- | |- | ||
| | |Bluetooth® icon flash or off | ||
|0x1000 | |0x1000 | ||
|BT icon is flashing or not | |BT icon is flashing or not | ||
Line 112: | Line 112: | ||
**1 - ON <br /> | **1 - ON <br /> | ||
**0 - OFF <br /> | **0 - OFF <br /> | ||
*In the example above, parameters from 1<sup>st</sup> ''instruction table'' are chosen. Those parameters are: ''Display battery level is ON; Error icon is ON; | *In the example above, parameters from 1<sup>st</sup> ''instruction table'' are chosen. Those parameters are: ''Display battery level is ON; Error icon is ON; Bluetooth® Broadcast is ON; Panel display is ON; Display speed is ON; Display unit is ON; Use mph units is ON.'' <br /> | ||
*When the parameters which you would like to enable are chosen, open ''Calculator'' software in ''Programmer'' mode, ''BIN'' (Binary) field again. <br /> | *When the parameters which you would like to enable are chosen, open ''Calculator'' software in ''Programmer'' mode, ''BIN'' (Binary) field again. <br /> | ||
*[[Image:Alert.png|20px|left]]<u>Starting '''from the bottom''' of the instruction table and '''moving upwards'''</u>, type the values (0/1) in the ''Calculator'' depending on if the parameter should be '''enabled''' (Value 1) or '''disabled''' (Value 0). <br /> | *[[Image:Alert.png|20px|left]]<u>Starting '''from the bottom''' of the instruction table and '''moving upwards'''</u>, type the values (0/1) in the ''Calculator'' depending on if the parameter should be '''enabled''' (Value 1) or '''disabled''' (Value 0). <br /> |