Jump to content

Command:scsetconfig: Difference between revisions

m
Text replacement - "Bluetooth" to "Bluetooth®"
m (Text replacement - "Bluetooth" to "Bluetooth®")
m (Text replacement - "Bluetooth" to "Bluetooth®")
Line 53: Line 53:
|Panel  display is turned on or off
|Panel  display is turned on or off
|-
|-
|Bluetooth® broadcast or not
|Bluetooth®® broadcast or not
|0x0400
|0x0400
|When  on, BT icon cannot control.
|When  on, BT icon cannot control.
Line 59: Line 59:
When  off, BT icon can define status: flash or always
When  off, BT icon can define status: flash or always
|-
|-
|Bluetooth® icon always on or off
|Bluetooth®® icon always on or off
|0x0800
|0x0800
|BT  icon is shown or not
|BT  icon is shown or not
|-
|-
|Bluetooth® icon flash or off
|Bluetooth®® icon flash or off
|0x1000
|0x1000
|BT  icon is flashing or not
|BT  icon is flashing or not
Line 112: Line 112:
**1 - ON <br />
**1 - ON <br />
**0 - OFF <br />
**0 - OFF <br />
*In the example above, parameters from 1<sup>st</sup> ''instruction table'' are chosen. Those parameters are: ''Display battery level is ON; Error icon is ON; Bluetooth® Broadcast is ON; Panel display is ON; Display speed is ON; Display unit is ON; Use mph units is ON.'' <br />
*In the example above, parameters from 1<sup>st</sup> ''instruction table'' are chosen. Those parameters are: ''Display battery level is ON; Error icon is ON; Bluetooth®® Broadcast is ON; Panel display is ON; Display speed is ON; Display unit is ON; Use mph units is ON.'' <br />
*When the parameters which you would like to enable are chosen, open ''Calculator'' software in ''Programmer'' mode, ''BIN'' (Binary) field again. <br />
*When the parameters which you would like to enable are chosen, open ''Calculator'' software in ''Programmer'' mode, ''BIN'' (Binary) field again. <br />
*[[Image:Alert.png|20px|left]]<u>Starting '''from the bottom''' of the instruction table and '''moving upwards'''</u>, type the values (0/1) in the ''Calculator'' depending on if the parameter should be '''enabled''' (Value 1) or '''disabled''' (Value 0). <br />
*[[Image:Alert.png|20px|left]]<u>Starting '''from the bottom''' of the instruction table and '''moving upwards'''</u>, type the values (0/1) in the ''Calculator'' depending on if the parameter should be '''enabled''' (Value 1) or '''disabled''' (Value 0). <br />
6,023

edits