Difference between revisions of "SIMPLE-CAN"

From Wiki Knowledge Base | Teltonika GPS
Line 30: Line 30:
 
| 0.91 mA
 
| 0.91 mA
 
|}
 
|}
−
==Installation notes==
+
 
−
If [[LV-CAN200]] or [[ALL-CAN300]] connection requires '''two CAN lines''' to get all data, then you need '''two SIMPLE-CAN readers'''. <br> <br>
 
−
SIMPLE-CAN works in the '''listening mode only''', so not all the data available on the CAN-BUS may be received using this solution. The '''device automatically sets CAN L/H polarity''', but the calibration has to be always executed during installation process. Connection of previously calibrated unit to another car needs new calibration because the reader '''automatically adjusts signal level and speed''' to different CAN-BUSes. The device also '''automatically adapts''' to the found '''noise level'''.
 
−
<br><br>
 
−
After power supply connecting, LED shines continuously. It means that device awaits for calibration. '''Calibration process''' has to be carried out when CAN-BUS twisted pair is tightened on SIMPLE-CAN and when the ignition is ON. Please press the switch shortly and wait for the LED to start blinking every 1 second. Automatic calibration process takes up to 10 seconds depending on the vehicle's model. Correct calibration process is confirmed by LED's every 2 seconds blink (when the CAN-BUS is active). When the CAN-BUS enters sleep mode, SIMPLE-CAN device does it also and takes 1,6mA/12V. In the sleep mode LED does not shine. If after calibration process LED shines continuously, it means that device is not calibrated yet, CAN-BUS transmission has failed or ignition during calibration was not ON.
 
 
==External Links==
 
==External Links==
 
[https://teltonika.lt/product/simple-can/ SIMPLE-CAN Teltonika]
 
[https://teltonika.lt/product/simple-can/ SIMPLE-CAN Teltonika]

Revision as of 09:06, 10 December 2018

Main Page > EOL Products > SIMPLE-CAN
SIMPLE-CAN.png

SIMPLE-CAN is contactless adapter used to read vehicle CAN data with LV-CAN200, ALL-CAN300 and FM6320/FMB630.

Features

  • SIMPLE-CAN collects vehicle data from CAN bus without damaging the wires
  • Powered from on-board power source
  • Reads the signals through the isolation of CAN bus wires
  • Easy to install and operate

Technical details

  • Power supply voltage 9-63 V
  • Operating temperature range -40°C ÷ +85°C
  • Dimensions 41,0 x 42,1 x 14,5 mm
  • Weight 23,6 g
  • CAN-BUS speeds from 33,33 to 500 kb/s
  • Automatically sets CAN Low, CAN High polarity
  • Automatically adjusts signal level and speed
  • Power supply current:
MODE 12V 24V
Active 8.3 mA 4.3 mA
Standby 1.6 mA 0.91 mA

External Links

SIMPLE-CAN Teltonika

YouTube

Teltonika CAN adapters Part 1: Introduction
Teltonika CAN adapters Part 2: Installation

FAQ

How to install SIMPLE-CAN with LVCAN-200 and ALLCAN-300?

Retrieved from "https://wiki.teltonika-gps.com/index.php?title=SIMPLE-CAN&oldid=24614"