Difference between revisions of "ECAN01"

Revision as of 09:57, 22 January 2020

ECAN01 (Easy-CAN) is contactless adapter used to read vehicle CAN Bus data. ECAN01 (Easy-CAN) adapter should be used in combination with:

It reads can bus data through the isolation of wires without damaging them and forwards signals to tracking device.


PARAMETER	VALUE
PARAMETER	Minimum	Typical	Maximum	Unit
Supply Voltage
Supply Voltage (Recommended Operating Conditions)	+10	+12	+30	V
Current Consumption
Working Mode		6.9		mA
Sleep Mode		1.2		mA
Operating Temperature
Operating Temperature	-25		+85	°C
Protection
Internal resettable fuse (max 33 V)			750	mA


PIN NUMBER	PIN NAME	DESCRIPTION
1	CAN L	(Blue) Connect to CAN L input of CAN BUS converter
2	CAN H	(White/Blue) Connect to CAN H input of CAN BUS converter
3	VCC	(RED) Power supply (10-30) V DC (+)
4	GND (-)	(Black) Ground wire (10-30) V DC (-)

Gently open ECAN01 cover using plastic pry tool from both sides
Insert CAN wires as shown in figure 5. Please make sure that correct slots are used (CAN High/CAN Low)
Gently close the device.
Device is ready-to-use.

@@ Line 105: / Line 105: @@
 ==Set up ECAN01==
-# Gently remove {{{model|FMB1YX}}} '''cover''' using '''plastic pry tool''' from both sides.<p><b>Note:</b> To properly open a new case please watch this [https://youtu.be/PBXVNXfRjg0 video].</p>
+# Gently open ECAN01 cover using plastic pry tool from both sides
-# Insert '''{{{sim_type|Micro-}}}SIM''' card as shown with '''PIN request disabled''' or read '''[[{{{model|FMB1YX}}} Security info|Security info]]''' how to enter it later in [[Teltonika Configurator]]. Make sure that {{{sim_type|Micro-}}}SIM card '''cut-off corner''' is pointing forward to slot. {{{dual_sim|'''SIM slot 1''' is closer to PCB, '''SIM slot 2''' is the upper one.}}}
+# Insert CAN wires as shown in figure 5. Please make sure that correct slots are used (CAN High/CAN Low)
-{{{be_battery|# Connect '''battery''' as shown to device. Position the battery in place where it does not obstruct other components.
+# Gently close the device.
-# After '''configuration''', see “'''[[{{{model|FMB1YX}}}_First_Start#PC Connection (Windows)|PC Connection (Windows)]]'''”, attach device '''cover''' back.}}}
+# Device is ready-to-use.
 [[Image:{{{sim_insert_pic1|Fmb120_cover_1.png}}}|260px]][[Image:{{{sim_insert_pic2|Fmb120_cover_2.png}}}|260px]][[Image:{{{sim_insert_pic3|Fmb120_cover_3.png}}}|260px]][[Image:{{{sim_insert_pic4|Fmb120_cover_4.png}}}|260px]]