FMP100 User Interface

Indication is configurable in User Interface tab of configurator or via SMS/GPRS parameter ID. Each 100 ms device checks if any indication is enabled in response to triggered scenarios. If two scenarios need to indicate on the same indication source (LED or Vibration) then the active indicating scenario needs to be finished first (with exception of Alarm and Device Off scenarios, which can override the control of indication sources). Period setting is indicative of Periodic scenarios and if Period is set to 0 the indication will take place immediately. When indication is periodic and On parameter value is set to 0, the indication source will stay on until the scenario is finished. Triggered scenarios will turn on LED and/or Vibration for a configured On duration and then keep them off for a configured Off period of time. In case the configured Repeat value is higher than 0 the device continues a periodic on/off cycle. Enable In Sleep parameter will let the indication work while device is sleeping.

GSM Indication

Name	Meaning
GSM Error	SIM is not inserted, failed to connect to GSM operator or GSM signal is being jammed
GSM Signal Established	Device successfully registered to GSM network
SMS Send/Receive	SMS is received or sent
Incoming Call	Device notices incoming call
Remote Connection	Device establishes connection with the server

GNSS Indication

Name	Meaning
No GPS Fix	Device searches for valid GPS fix
GPS Fix	Device has valid GPS fix

Event Indication

Name	Meaning
Event	Eventual record is saved
Panic Event	Panic record is saved
Device Off	Device is turning off
Device On	Device is turning on
Pre Alarm	Indication when Man-down or No Movement event functionality starts counting timeout till event
I Am Alive	Periodical indication that device is on
Sleep Mode	Device is in sleep mode

Note! three LED colors are available - Green, Red and Blue. Indications are fully customizable depending on the user needs.