ECAN02
Revision as of 15:57, 8 February 2023 by Arnas.Zeb (talk | contribs) (Created page with "right|400px right|400px [https://teltonika-gps.com/product/ECAN02/ ECAN02] is contactless adapter used to read vehicle [http...")
Main Page > CAN Trackers & Adapters > ECAN02
ECAN02 is contactless adapter used to read vehicle CAN Bus data. ECAN02 adapter should be used in combination with:
It reads can-bus data through the isolation of wires without damaging them and forwards signals to the tracking device.
Features
- ECAN02 collects vehicle data from CAN bus without damaging the wires
- Powered from an on-board power source
- Reads the signals through the isolation of CAN bus wires
- Easy to install and operate
Technical features
PARAMETER | VALUE | ||||
---|---|---|---|---|---|
Minimum | Typical | Typical | Maximum | Unit | |
Supply Voltage | |||||
Supply Voltage (Recommended Operating Conditions) | +10 | +12 | +24 | +30 | V |
Current Consumption | |||||
Working Mode | 7.6 | mA | |||
Sleep Mode | 1.7 | mA | |||
Operating Temperature | |||||
Operating Temperature | -25 | +85 | °C | ||
Protection | |||||
Internal resettable fuse (max 33 V) | 750 | mA |
- Dimensions 39.8 x 12 x 19 mm
- CAN-BUS speeds up to 1000 kb/s
- Fuse is protecting devices from high current peaks. If the voltage exceeds 33V (i.e. 35V) then protection diode stabilizes device voltage to 33V and the current value will increase accordingly.
Pinout
PIN NUMBER | PIN NAME |
DESCRIPTION |
---|---|---|
1 | CAN L | (Blue) Connect to CAN L input of CAN BUS converter |
2 | CAN H | (White/Blue) Connect to CAN H input of CAN BUS converter |
3 | VCC | (RED) Power supply (10-30) V DC (+) |
4 | GND (-) | (Black) Ground wire (10-30) V DC (-) |
Wiring scheme
Set up ECAN02
- Gently open ECAN02 cover using plastic pry tool from both sides
- Glue double-sided adhesive tape to casing inside as shown in figure 2 remove backing material
- Insert CAN wires as shown in figure 3. Please make sure that correct slots are used (CAN High/CAN Low)
- Close the device.
- Device is ready-to-use.