It reads can bus data through the isolation of wires without damaging them and forwards signals to tracking device.
Features
Easy-CAN collects vehicle data from CAN bus without damaging the wires
Powered from on-board power source
Reads the signals through the isolation of CAN bus wires
Easy to install and operate
Technical features
PARAMETER
VALUE
Minimum
Typical
Maximum
Unit
Supply Voltage
Supply Voltage (Recommended Operating Conditions)
+10
+12
+30
V
Current Consumption
Working Mode
6.9
mA
Sleep Mode
1.2
mA
Operating Temperature
Operating Temperature
-25
+85
°C
Protection
Internal resettable fuse (max 33 V)
750
mA
Dimensions 39.8 x 18 x 16.7 mm
CAN-BUS speeds up to 1000 kb/s
Pinout
PIN NUMBER
PIN NAME
DESCRIPTION
1
CAN L
(Blue) Connect to CAN L input of CAN BUS converter
2
CAN H
(White/Blue) Connect to CAN H input of CAN BUS converter
3
VCC
(RED) Power supply (10-30) V DC (+)
4
GND (-)
(Black) Ground wire (10-30) V DC (-)
Wiring scheme
Set up ECAN01
Gently remove FMB1YX cover using plastic pry tool from both sides.
Note: To properly open a new case please watch this video.
Insert Micro-SIM card as shown with PIN request disabled or read Security info how to enter it later in Teltonika Configurator. Make sure that Micro-SIM card cut-off corner is pointing forward to slot. SIM slot 1 is closer to PCB, SIM slot 2 is the upper one.
Connect battery as shown to device. Position the battery in place where it does not obstruct other components.
