ECAN01
From Wiki Knowledge Base | Teltonika GPS
Revision as of 11:29, 27 February 2020 by Aurimas.adomaitis (talk | contribs)
Main Page > CAN Trackers & Adapters > ECAN01
ECAN01 is contactless adapter used to read vehicle CAN Bus data. ECAN01 adapter should be used in combination with:
It reads can bus data through the isolation of wires without damaging them and forwards signals to tracking device.
Features
- ECAN01 collects vehicle data from CAN bus without damaging the wires
- Powered from on-board power source
- Reads the signals through the isolation of CAN bus wires
- Easy to install and operate
Technical features
| PARAMETER | VALUE | |||
|---|---|---|---|---|
| Minimum | Typical | Maximum | Unit | |
| Supply Voltage | ||||
| Supply Voltage (Recommended Operating Conditions) | +10 | +12 | +30 | V |
| Current Consumption | ||||
| Working Mode | 6.9 | mA | ||
| Sleep Mode | 1.2 | mA | ||
| Operating Temperature | ||||
| Operating Temperature | -25 | +85 | °C | |
| Protection | ||||
| Internal resettable fuse (max 33 V) | 750 | mA | ||
- Dimensions 39.8 x 18 x 16.7 mm
- CAN-BUS speeds up to 1000 kb/s
Pinout
| PIN NUMBER | PIN NAME |
DESCRIPTION |
|---|---|---|
| 1 | CAN L | (Blue) Connect to CAN L input of CAN BUS converter |
| 2 | CAN H | (White/Blue) Connect to CAN H input of CAN BUS converter |
| 3 | VCC | (RED) Power supply (10-30) V DC (+) |
| 4 | GND (-) | (Black) Ground wire (10-30) V DC (-) |
Wiring scheme
Set up ECAN01
- Gently open ECAN01 cover using plastic pry tool from both sides
- Insert CAN wires as shown in figure 5. Please make sure that correct slots are used (CAN High/CAN Low)
- Gently close the device.
- Device is ready-to-use.
ECAN01 Certification & Approvals
Nomenclature, classification codes
FAQ
- How to install SIMPLE-CAN with LV-CAN200/ALL-CAN300 using:
- FMB110
- FMB120
- FMB122
- FMB125
- FMB110
- FMA120
- FMB630
- FMB640
- FM6300
- FM6320
- FM36M1
- FM3622
- FM3612
YouTube
Teltonika CAN adapters Part 1: Introduction
Teltonika CAN adapters Part 2: Installation
