Changes

'''CONNECTING WIRES'''

'''CONNECTING WIRES'''

# Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or moving objects should be kept away from the wires.<br />

• Wires should be fastened to stable wires or other non-moving parts. Any heat emitting and/or moving objects should be kept away from the wires.<br />

# There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied.<br />

• There should be no exposed wires. If factory isolation was removed while connecting wires, the isolation material should be applied.<br />

# If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be <br />applied and the wires should not be loose.<br />

• If the wires are placed in the exterior or in places where they can be damaged or exposed to heat, humidity, dirt, etc., additional isolation should be <br />applied and the wires should not be loose.<br />

# Wires cannot be connected to the board computers or control units.<br />

• Wires cannot be connected to the board computers or control units.<br />

'''CONNECTING POWER SOURCE'''

'''CONNECTING POWER SOURCE'''

# Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.<br />

• Be sure that after the car computer goes to sleep mode, power might be still available on the power wires. Depending on car, this may happen in 5 to 30 minutes period.<br />

# When module is connected, measure voltage again to make sure it did not decrease.<br />

• When module is connected, measure voltage again to make sure it did not decrease.<br />

# It is recommended to connect to the main power cable in the fuse box.<br />

• It is recommended to connect to the main power cable in the fuse box.<br />

# 3 A, 125 V external fuse shall be used.<br />

• 3 A, 125 V external fuse shall be used.<br />

'''CONNECTING GROUND WIRE'''

'''CONNECTING GROUND WIRE'''

# Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.<br />

• Ground wire is connected to the vehicle frame or metal parts that are fixed to the frame.<br />

# If the wire is fixed with the bolt, the loop must be connected to the end of the wire.<br />

• If the wire is fixed with the bolt, the loop must be connected to the end of the wire.<br />

# For better contact scrub paint from the spot where loop is going to be connected.<br />

• For better contact scrub paint from the spot where loop is going to be connected.<br />

[[Category:FTC921]]

[[Category:FTC921]]