Difference between revisions of "MSP500 Auto Geofence settings"
m (Protected "MSP500 Auto Geofence settings" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
(Created page with "{{ Template:FMB Auto Geofence settings |model=MSP500 |pic_autogeofence=300px|right |text_din= * <span style=color:#F6A83E>Power Voltage</span...") |
||
| (One intermediate revision by the same user not shown) | |||
| Line 2: | Line 2: | ||
Template:FMB Auto Geofence settings | Template:FMB Auto Geofence settings | ||
|model=MSP500 | |model=MSP500 | ||
| − | |pic_autogeofence=[[Image: | + | |pic_autogeofence=[[Image:MSP500 autogeofence.png|300px|right]] |
|text_din= | |text_din= | ||
* <span style=color:#F6A83E>Power Voltage</span> – If power voltage becomes higher than low voltage level (defined in Ignition settings). | * <span style=color:#F6A83E>Power Voltage</span> – If power voltage becomes higher than low voltage level (defined in Ignition settings). | ||
Revision as of 05:02, 26 March 2020
Main Page > EOL Products > MSP500 > MSP500 Configuration > MSP500 Auto Geofence settingsAutoGeofence is based on the last known position after the movement has stopped. You can be notified using this function if your car is taken away. The shape and size of Geofence zones are set by parameters. It is possible to state whether entering or leaving the geofence triggers an asynchronous message.
AutoGeofencing options can be configured by following parameters as depicted in the right hand side figure:
Activation timeout defines the delay between the creation of AutoGeofence within set Radius value around vehicle's most recent position and when the ignition is off. Note that AutoGeofencing does not require entering coordinates, instead it requires GPS visibility. Event generation can take place on Geofence Entrance, Exit or On Both. Eventual Records is used to enable or disable Eventual Records functionality. AutoGeofence can be deactivated by:
- Power Voltage – If power voltage becomes higher than low voltage level (defined in Ignition settings).
- Engine RPM – If engine RPM value becomes higher than 0.
