Difference between revisions of "MSP500 System settings"
From Wiki Knowledge Base | Teltonika GPS
(2 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
− | {{Template: | + | {{Template:FMB System settings |
|model=MSP500 | |model=MSP500 | ||
|analog_input = | |analog_input = | ||
Line 7: | Line 7: | ||
|input_mode = | |input_mode = | ||
|voltage = | |voltage = | ||
− | <!---|template_link={{Template: | + | <!---|template_link={{Template:FMB9 Movement parameters}} |
|pic_system=[[File:MSP500 System settings v0.16.1.17313.png|800px|none]] | |pic_system=[[File:MSP500 System settings v0.16.1.17313.png|800px|none]] | ||
}} | }} | ||
'''Note:''' ''If record is without valid coordinates – (there were no GPS fix in the moment of data acquisition) – Longitude, Latitude and Altitude values are last valid fix, and Angle, Satellites and Speed are 0. After a reboot, it will send zero coordinates.''---> | '''Note:''' ''If record is without valid coordinates – (there were no GPS fix in the moment of data acquisition) – Longitude, Latitude and Altitude values are last valid fix, and Angle, Satellites and Speed are 0. After a reboot, it will send zero coordinates.''---> | ||
− | |||
[[Category:MSP500 Configuration]] | [[Category:MSP500 Configuration]] |
Revision as of 02:25, 20 April 2020
Main Page > EOL Products > MSP500 > MSP500 Configuration > MSP500 System settings{{Template:FMB System settings |model=MSP500 |analog_input = |txt_din3 = |txt_fmb208_show = |txt_fmb208_enable = |input_mode = |voltage =