Difference between revisions of "FMB140 Accessories"
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
|CAN-CONTROL = | |CAN-CONTROL = | ||
}} | }} | ||
| − | [[Category:FMB140 Manual | + | [[Category:FMB140 Manual]] |
Revision as of 12:53, 12 October 2021
Main Page > CAN Trackers & Adapters > FMB140 > FMB140 Manual > FMB140 AccessoriesEYE Beacon
BLE Beacon for traceability use cases, delivery tracking, monitoring of various movable objects in logistics (trailers, containers), agriculture (tractor attachments), and constructions (tools and inventory).
EYE Sensor
Sensors data makes it especially suitable for cold chain refrigerator use cases. The built-in accelerometer can detect item movement or fall events. Magnet detection can be used for wireless open/close detection and notifications such as trailer door events, etc.
ECAN01
Contactless connection to the CAN bus of the vehicle! It reads can bus data through the isolation of wires without damaging them and forwards signals to tracking device.
Analog Fuel Sensor
Fuel tracking is one of the key challenges of fleet management. If the vehicle has a factory installed Analog Fuel Sensor, there is a solution that does not require any additional equipment - you can connect the device via AIN to read the fuel data straight from the sensor
1-Wire Temperature Sensor
Digital temperature sensor probe is based on Dallas DS18B20 sensor. An 8 meter cable length will not require any additional wires for even the most demanding installation places. These sensors operate in wide temperature range from -55°C to 125°C.
1-Wire TTJ Temperature Sensor
The TTJ communicates over a 1-Wire bus that by definition requires only one data line (and ground) for communication with a central microprocessor. It has an operating temperature range of –55°C to +125°C and is accurate to ±0,5°C over the range of –10°C to +85°C.
1-Wire iButton Reader
One of the implemented features for fleet management devices is 1-Wire data protocol, which enables connection of iButton. The iButton device is perfect for any application where AVL data needs to travel along with a person or object identification.
1-Wire RFID Reader
The easy solution for implementing driver authentication using RFID based on DS1990A. Read is able to receive identification data wirelessly from passive transponders (cards, tags, etc.)
