312
edits
Changes
→Crash Detection Functionality using DOUT
==DSM configuration for FMx650==
==DSM configuration for FMx650==
'''(!) Required firmware version - 03.00.14.Rev.114'''. [[DSM_Firmware_errata|Firmware errata.]]
*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]
*Make sure '''Data Protocol''' is set to [[Codec#Codec_8_Extended | Codec 8 Extended]]
------------------
------------------
The new feature for FMx650 DSM configuration, which is available from '''03.00.14.Rev.114 iCamera''' allows you to connect two of your cameras at once. Method for connection and configuration stays the same, for this you are only required to choose '''two''' cameras in '''"RS232 \ RS485"''' tab from the configurator.
The new feature for FMx650 DSM configuration, which is available from '''03.00.14.Rev.114 iCamera''' allows you to connect two of your cameras at once. Method for connection and configuration stays the same, for this you are only required to choose '''two''' cameras in '''"RS232 \ RS485"''' tab from the configurator.
In the new functionality, you are able to connect any combo of the cameras by your wish, as an example: you are able to connect ''DSM/Dualcam'', ''DashCam/DualCam'', ''DSM/DSM'', ''DualCam/DualCam'' and etc.
[[File:Twincamera.gif|500px]]
[[File:Twincamera.gif|500px]]
*Periodic image sending - Periodic image sending can be sent in order to send images to the server at a configurable time period.
*Periodic image sending - Periodic image sending can be sent in order to send images to the server at a configurable time period.
*Image sending trigger - Triggers can be set in order to activate image sending. Crash/Towing/Idling/Geofence/Unplug/Green driving are actual features of the FMX640 family devices and are configured under '''[[FMC640_Features_settings | Features]] / [[FMC640_Accelerometer_Features_settings | Accelerometer Features]] / [[FMC640_Manual_Geofence_zones | Geofence]] / [[FMC640_Trip/Odometer_settings | Trip/Odometer]]''' Tabs.
*Image sending trigger - Triggers can be set in order to activate image sending. Crash/Towing/Idling/Geofence/Unplug/Green driving are actual features of the FMX640 family devices and are configured under '''[[FMC640_Features_settings | Features]] / [[FMC640_Accelerometer_Features_settings | Accelerometer Features]] / [[FMC640_Manual_Geofence_zones | Geofence]] / [[FMC640_Trip/Odometer_settings | Trip/Odometer]]''' Tabs.
==Crash Detection Functionality using DOUT==
'''The crash detection feature''' is a crucial capability provided by our device. It enhances evidential documentation through video or photo evidence in the event of a crash. However, activating this functionality necessitates a direct connection of the camera to a power source. Nonetheless, such a direct connection can lead to '''battery drainage'''.
To circumvent this issue, we recommend utilizing DOUT and a relay for connection. This setup enables control via SMS or GPRS command, or through predefined scenarios within our device. By activating DOUT post-ignition, the camera receives power, allowing it to function and record evidence even after the ignition is turned off following a crash. '''For your convenience, the connection scheme can be found here: [[DSM First Start]]'''
'''It is important to note that in the event of a fatal crash where fatalities may occur,''' we cannot guarantee the retrieval of video or photo evidence due to the severity of the accident. Moreover, both the camera and the device itself may sustain irreparable damage in such instances
[[Category:DSM]]
[[Category:DSM]]