Difference between revisions of "ECAN02"

Revision as of 14:14, 30 March 2023

ECAN02 is contactless adapter used to read vehicle CAN Bus data. ECAN02 adapter should be used in combination with:

It reads can-bus data through the isolation of wires without damaging them and forwards signals to the tracking device.


PARAMETER	VALUE
PARAMETER	Minimum	Typical	Typical	Maximum	Unit
Supply Voltage
Supply Voltage (Recommended Operating Conditions)	+10	+12	+24	+30	V
Current Consumption
Working Mode		7.6			mA
Sleep Mode		1.7			mA
Operating Temperature
Operating Temperature	-25			+85	°C
Protection
Internal resettable fuse (max 33 V)			750		mA

Dimensions 39 x 12 x 19 mm
CAN-BUS speeds up to 1000 kb/s
Fuse is protecting devices from high current peaks. If the voltage exceeds 33V (i.e. 35V) then protection diode stabilizes device voltage to 33V and the current value will increase accordingly.


PIN NUMBER	PIN NAME	DESCRIPTION
1	CAN L	(Blue) Connect to CAN L input of CAN BUS converter
2	CAN H	(White/Blue) Connect to CAN H input of CAN BUS converter
3	VCC	(RED) Power supply (10-30) V DC (+)
4	GND (-)	(Black) Ground wire (10-30) V DC (-)

Gently open ECAN02 cover using plastic pry tool from both sides.
Remove backing material on one side of double-sided adhesive tape.
Glue double-sided adhesive tape to casing.
Remove backing material on double-sided adhesive tape.
Insert CAN wires. Please make sure that correct slots are used (CAN High/CAN Low).
Close the device.
Device is ready-to-use.

@@ Line 110: / Line 110: @@
 [[File:ECAN02 wiring scheme.png|center]]
-==Set up ECAN02==
+==Setup ECAN02==
 # Gently open ECAN02 cover using plastic pry tool from both sides.