Difference between revisions of "How to Install FMC640 on DAF XF"
From Wiki Knowledge Base | Teltonika GPS
m (Protected "How to Install FMC640 on DAF XF" ([Edit=Allow only administrators] (indefinite) [Move=Allow only administrators] (indefinite))) |
|||
| Line 21: | Line 21: | ||
* After installation and device configuration of FMC640 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also. | * After installation and device configuration of FMC640 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also. | ||
| − | [[Category:FMC640 Manual]] | + | [[Category:FMC640 Manual| 9]] |
Latest revision as of 17:36, 7 December 2021
Main Page > EOL Products > FMC640 > FMC640 Manual > How to Install FMC640 on DAF XF
Installation proccess
- Below is shown main installation location:
- Carefully unscrew the fuse panel screws and fold the panel down.
- Where to find main connector?
- Connect the wires accordingly. It is recommended to use DIN 1 instead of DIN 3 for ignition detection.
- After installation and device configuration of FMC640 (CAN1 should be selected – FMS/TACHO), you can check if installation is properly made. Turn on ignition of vehicle and send SMS command: “ tachocheck”. If response shows: “Can1:111,F2EF”, 111 -means tachograph properly connected, F2EF - or any other value which is not equal to 0000, means FMS data received also.
