ECAN01 E-Mark

From Wiki Knowledge Base | Teltonika GPS
Main Page > CAN Trackers & Adapters > ECAN01 > ECAN01 E-Mark

E-Mark is the regulations issued by the Economic Commission for Europe (referred to as ECE).

Standards applied

This Approval shall apply to a type of electrical/electronic sub assemblies (ESA) from serial production under the following conditions:

Individual products from serial production shall comply at least with all requirements set out in the Regulation No. 10 R, Amendment 05, Supplement 01 "Uniform provisions concerning the approval of vehicles with regard to electromagnetic compatibility".

Approval no.: E25 R10-05 0015

Extension No.: 00

The attached test report and drawings shall be a constituent part of this Approval.

Every product shall be marked with a readable and durable:

- approval marking.

This type of product shall be allotted the following approval marking:

FM3612 E-mark.jpg

Attachments

ECAN01 E-mark page 1
ECAN01 E-mark page 2
ECAN01 E-mark page 3

You can find the PDF version of the certificate here.

Disclaimer:

Test reports that are referenced in declarations and certificates can be provided upon request. For the request to be approved, the recipient of the test reports should be a certification authority or certified test house. The recipients will be asked to sign a non-disclosure agreement (NDA).

https://unece.org/fileadmin/DAM/trans/main/wp29/wp29regs/2019/E-ECE-324-Add.9-Rev.6.pdf