Template:FMx CAN Adapters

This document describes the steps to install and configure the following CAN adapters with your Teltonika tracker:

• LV-CAN200
• ALL-CAN300
• CAN-CONTROL
• ECAN02

Possible CAN Data Reading Configurations

Teltonika CAN series trackers have an integrated CAN chip which can be used to read CAN bus data directly from the vehicle. This is not discussed here, see separate pages of CAN series trackers.

CAN adapters allow expanding a non-CAN tracker’s functionality.

Additionally, you can use the contactless ECAN02 adapter when insurance limitations do not allow modification of the wiring.

To summarize, the four possible configurations to read CAN data are:

1. (wired) CAN tracker
2. (wired) Non-CAN tracker + CAN adapter
3. (contactless) CAN tracker + ECAN02 adapter
4. (contactless) Non-CAN tracker + CAN adapter + ECAN02 adapter

CAN Adapter Installation

We recommend watching the videos for an overview of CAN adapters and their installation:

• Teltonika CAN adapters Part 1: Introduction
• Teltonika CAN adapters Part 2: Installation
• Contactless CAN data reading with ECAN02
• Example installation guide with FMx150 & ECAN02

Items Required for Installation

1. Connection schematic for your vehicle (to get the schematic, contact your Teltonika sales representative and provide the required vehicle make, model and year)
2. CAN adapter LV-CAN200 / ALL-CAN300 / CAN-CONTROL
3. Optional: ECAN02 for contactless reading. See below for separate instructions for ECAN02 installation
4. {{{model}}} device
5. Quick splice connectors (if the CAN bus wires of your vehicle are very thin, connect CAN adapter wires directly)
6. Pliers
7. Plastic pry tool
8. Zip ties

Installation Procedure

NOTE! The maximal number of vehicle CAN lines that can be read depends on the number of available CAN pairs on your CAN-enabled tracker/CAN adapter.